Get RAPTOR

Editing

The tool panel beside the toolbar lists the operations for the current mode. one or press its hotkey. Operations that cannot act on the selection are disabled.

  • Polygon (ShiftP) draws a new Block by outline, in every mode.
  • Repeat (ShiftG) runs the last operation again on the current selection.

The panel's menu sets its layout:

OptionEffect
AutoFits the columns to the panel's width
Two columnsLays the rows out in two columns
One columnLays the rows out in one column
Icons onlyShows icons without names

Operations with settings, such as Inset, show them in the context bar and at the bottom of the 3D view. See Tools with settings.

Operations by mode

OperationHotkeyAction
ConnectVJoins the corners with an edge
BevelFCuts the corner off
Bevel toolAltFBevels or rounds the corner with the width and segments you set
Edge cutCCuts new edges across faces
MergeShiftMJoins the corners into one
Snap to lastBMoves the corners onto the last one selected
Snap to gridCtrlBPuts the corners back on the grid
DeleteDelRemoves the corners
Weld UVsCtrlFJoins the texture at the corners

Broken faces

A Mesh health section appears when the selection has folded or bent faces. Folded faces break rendering and collision, and bent faces render with a crease.

OperationAction
Clean up allRuns the three fixes below
Remove broken facesDeletes the folded faces
Make faces planarFlattens bent faces
Weld doubled verticesJoins overlapping corners