Get RAPTOR

Creating your first room

Build a room from a single Block.

Drawing the room

The room is one hollow Box.

Pick New Block

→ New Block from the toolbar. Or use the hotkey ShiftB. Press and hold it to pick another shape.

Make the Box hollow

In the context bar, set Shell to Hollow. Its faces point inward and form the walls, floor and ceiling.

Draw it

In the 3D view:

  1. the first corner of the floor.
  2. the opposite corner.
  3. Move up to set the height, and .

Enter to apply, Esc to cancel.

Corners snap to the grid. [ makes the grid finer and ] makes it coarser.

The Block is added to a new model, listed in Hierarchy under Models.

Shaping the room

Pick which part of the Block to edit:

HotkeyAction
1Switches to Vertex mode, for corners
2Switches to Edge mode, for edges
3Switches to Face mode, for faces
4Switches to Object mode, for whole Blocks

to select. Shift to add more. The tool panel beside the toolbar lists the operations for the selection, with their hotkeys.

Try these on the room:

OperationAction
MoveMoves the selection. Select a wall in Face mode and the gizmo's arrow
ExtrudePulls a face out and adds sides around it. Shift a selected face
InsetAdds a smaller face inside each selected face. Press ShiftI, set Amount, then press Enter
Edge cutCuts new edges across faces. Press C, points, then press Enter
Snap to a cornerMoves the selection so one of its corners meets another Block's corner. Tab the corner
RulerMeasures a distance. M in the 3D view

CtrlZ to undo. For every hotkey, see Hotkeys.

Adding a doorway

A doorway takes three cuts in a wall: one down each side and one across the top. Use Edge cut or Connect.

Open Edge cut

Press C.

Cut the sides

a point on the wall's floor edge, then a point on its ceiling edge. Hold Shift to keep the cut straight. Press B to apply and keep the tool open.

Make the second cut one door width along the wall.

Cut the top

a point on the first cut at door height, then a point on the second cut. Press Enter to apply.

Select the new door-shaped face in Face mode. Shift it outward to extrude a corridor, or press Del to delete it and leave an opening.

Building and saving

Blocks are the editable shape of a model. Building turns them into the meshes and colliders used in the game.

Build

Select the model. The Inspector shows Built or Not built.

→ Build

Turn on Auto to rebuild about a second after you stop editing.

Save

→ Model → Save in the top bar

The room is saved as a prefab in Assets/RAPTOR Data/Models.

Model → Open models lists every saved model.

Select one and → Load into scene.

Next: Texturing your room.