Drawing Blocks
Drawing a Block
Pick New Block
→ New Block from the toolbar. Or use the hotkey ShiftB.
Set the first corner
on the grid, or on a Block's face to draw on that face.
Set the far corner
the far corner of the base.
Set the height
Move up and . Enter or Space to apply, Esc to cancel.
With Snap to vertex on, the first corner snaps to nearby Block corners and edges.
The new Block is selected in Object mode with the resize gizmo, and uses the active material.
Choosing a shape
Hold New Block and pick a shape. Its settings are in the context bar.
| Option | Effect |
|---|---|
| Box | Draws a box. Faces sets which of the six sides are made |
| Cylinder | Draws a cylinder with 3 to 64 Sides |
| Sphere | Draws a sphere with 3 to 32 Sides |
| Stairs | Draws stairs with 2 to 64 Steps. Align to camera turns them to face the view |
| Cone | Draws a cone with 3 to 64 Sides |
| Doorway | Draws a doorway with Door width, Door height, Arch height, Arch segments, Outer faces and Align to camera |
| Quad | Draws one flat face, with no height to set. Back face adds a face on the other side |
A Box's Shell sets which way its faces point:
| Option | Effect |
|---|---|
| Solid | Points the faces outward |
| Hollow | Points the faces inward |
| Two sided | Points the faces both ways |
Creating a room
Draw a Box with Shell set to Hollow. Its walls, floor and ceiling face inward.
Drawing by outline
Press ShiftP to open the Polygon tool.
- the shape's corners.
- the first point again, or press Enter, to close it.
- Move to set the height, and .
Backspace removes the last point.
Drawing in Top, Front or Side
In the flat views, 2D depth in the context bar sets the Block's depth:
| Option | Effect |
|---|---|
| Last | Uses the depth of the last Block you drew |
| Fixed | Uses the depth you type, in metres |
Drawing on a face
Start the first on a face to draw the Block on it. To keep drawing on the same face, set a workplane with ShiftQ. See Grid and workplane.
A Block's settings
The Inspector shows the selected Block's settings:
| Setting | Effect |
|---|---|
| Transform | Sets Position, Rotation and Size |
| Surface | Sets Smoothing: Hard, Soft, Default or an angle |
| Output | Sets its model's Collider and UV padding |
| Material | Shows the Block's material and how many faces use it |
The subdivision level is set in the tool panel. See Subdivision and displacement.
The Inspector's footer shows the Block's face, vertex and triangle counts.